QuickNet-RK Installation Instructions
7
This test ensures that the insulating jackets of the mat are not
damaged. A low value indicates the mat has been damaged and
must be replaced.
R = Open
or OL
White
Cold lead
Black
Ground
1. Connect the ground wire to the black lead and both power
wires to the red lead of the multimeter.
2. Set your multimeter to the 200 K ohm range. Make sure the
meter reads ‘Open’ or “OL’. If you get a different reading,
contact Tyco Thermal Controls at 800-545-6258.
3. Record these readings on the Commissioning Record (page 8).
This test measures the resistance of the mat and is used to deter-
mine circuit integrity.
R = ?Ω
See Table 1
1. Set your multimeter to the 200 ohm range.
2. Connect the multimeter leads to the black and white cold lead
wires.
3. Compare this resistance reading to the resistance specified in
the QuickNet Resistance Table below. The value should be with-
in ±10%. If you get a different reading, contact Tyco Thermal
Controls at 800-545-6258.
4. Record these readings on the Commissioning Record (page 8).
1 Insulation Resistance Test 2 Heating Cable Resistance Test
This test measures the resistance of the floor sensor and is
used to verify the sensor integrity.
Red
Green
R = 9 – 25 KΩ
1. Set your multimeter to the 200 K ohm range.
2. Connect the multimeter leads to the red and green lead wires.
3. Make sure the meter reads between 9–25 KΩ.
If you get a different reading, contact Tyco Thermal Controls
at 800-545-6258.
4. Record these readings on the Commissioning Record (page 8).
3 Sensor Resistance Test
Testing Procedure
QuickNet Mat Resistance Table
120 V QuickNet with thermostat
Catalog Number Size ft² (m²) Resistance Ohms
QUICKNET-010-1 10 (0.9) 120
QUICKNET-020-1 20 (1.9) 60
QUICKNET-030-1 30 (2.8) 40
QUICKNET-040-1 40 (3.7) 30
QUICKNET-050-1 50 (4.6) 24
QUICKNET-060-1 60 (5.6) 20
QUICKNET-070-1 70 (6.5) 17
QUICKNET-080-1 80 (7.4) 15
QUICKNET-090-1 90 (8.4) 13
QUICKNET-100-1 100 (9.3) 12
240 V QuickNet Mats with thermostat (and without thermostat)
Catalog Number Size ft² (m²) Resistance Ohms
QUICKNET-050-2 (-050X-2) 50 (4.6) 96
QUICKNET-060-2 (-060X-2) 60 (5.6) 80
QUICKNET-080-2 (-080X-2) 80 (7.4) 60
QUICKNET-100-2 (-100X-2) 100 (9.3) 48
Once the QuickNet splice is completed, conduct the following three commissioning tests on this page and record the values on the QuickNet-RK
Commissioning Record (on page 8). Retain these readings with the original QuickNet Commissioning Record.
(12 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern